MTW trapezium mill introduced to the Belarusian potash salt market

Potash salt is an important mineral for the production of potash fertilizer, which is abundant in Belarus and is widely used in agriculture and industry. In order to exploit the mineral resources more environmentally friendly and efficiently, Belarus decided to attract Chinese investment to enter the field of mineral resources development in Belarus by introducing MTW trapezium mill introduced to the Belarusian potash salt market.

There are many ways to produce potash fertilizer from potash salt, but the first thing we need is to pulverize the potash first, and then we can carry out flotation method, dissolution crystallization method, electrostatic separation method and hydraulic separation method. The MTW trapezium mill mentioned above is used for crushing potash salt. This equipment is developed by experienced grinding technology experts by introducing domestic and foreign crushing, grinding technology and environmental protection concepts. MTW European trapezoidal mill occupies a very large market share in the mine crushing and grinding industry. It has a number of independent patent technology property rights, unique bevel gear integral drive, internal thin oil lubrication system, arc air duct, etc. Devices are even more distinctive. The data shows that since 2022, the price of potash has generally declined first and then increased, and the market demand for potash salt has increased a lot. MTW trapezium mill introduced to the Belarusian potash salt market, will definitely lead to environmental protection and reasonable development. On the basis of increasing the output of potash.

MTW trapezium mill introduced to the Belarusian potash salt market
MTW trapezium mill introduced to the Belarusian potash salt market

Here we should especially remind that MTW trapezium mill needs to be tested for 30 minutes before it is officially put into work. Observe the running state of the main machine, whether the temperature of the bearing room exceeds 50℃ (under normal circumstances, it should not exceed 50℃), if everything is normal, we can stop the running state of the powder mill, tighten the bolts in turn, and then officially put into work. In the time of use afterwards, it is only necessary to check the bolts once a week to avoid loosening. If you have any needs or questions, please leave a message below, we will reply to you as soon as we receive it.

Leave a Comment

Your email address will not be published.